|
Installation Instructions
Model SC-915-5 Partition Wall Bracket
Santa Cruz Partition Wall Brackets are designed to be mounted between bucket seats on a partition wall in vertical muzzle-up position. The version above lets you setup for most any weapon in the same setup.
SC-5 Gun Lock
|
|
- Install SC-1900 Butt Plate on SC-9151 butt plate support bracket. Do not tighten screws just yet.
- Place weapon in butt plate and position the assembly at the bottom of the cage so the bracket is in the center of the drive shaft housing. Determine the correct angle of the bracket and mark mounting hole points in the lower panel of the cage. Drill two holes and install SC-9151 bracket using the supplied 5/16-18" carriage bolts, washers and nuts.
- Install the supplied Cross Bar in the rectengular hole at the bottom of the lock. Position SC-5 gun lock on the weapon at a location that will prevent the gun from lifting out of the butt plate. Mark mounting holes in Cross Bar over to the cage. Drill holes.
- Use the supplied thick washers under cross bar mounting holes and fasten cross bar - gun lock assembly to the partition wall with 2 x 5/16-18" carriage bolts.
- Install weapon in butt plate and gun lock. Readjust gun lock on cross bar and secure gun lock on bar using the supplied 5/32" allen key. Use the supplied sheet metal screw to fasten bottom curve of SC-9151 butt plate bracket to drive shaft housing.
- Insert and remove weapon from the setup several times to make sure the weapon is secure and also easy to take it out of the setup. Tighten all screws.
We reserve the right to change design and prices without notice.
HELP IS JUST A PHONE CALL AWAY
Should you have any problem installing or using Santa Cruz products, we are here to help you every step of the way.
Just give us a call at our toll free number (800) 847-5428 and we will be glad to help you with the installation, special part request or any other way you might need assistance.
^Back to Top
|
