|
Installation Instructions
Model SC-915-5-A Adjustable Partition Wall Bracket
 Santa Cruz Partition Wall Brackets are designed to be mounted between bucket seats on a partition wall in vertical muzzle-up position. The version above lets you exhange most any weapons in the same setup.
- Install SC-1900 Butt Plate on SC-9151 butt plate support bracket. Do not tighten screws just yet.
- Place weapon in butt plate and position the assembly at the bottom of the cage so the bracket is in the center of the drive shaft housing. Determine the correct angle of the bracket and mark mounting hole points in the lower panel of the cage. Drill two holes and install SC-9151 bracket using the supplied 5/16-18" carriage bolts.
- Position SC-502 Flat Bar directly in line over the butt plate assembly and mark mounting holes in flat bar over to the cage. Drill holes.
- Slide flat bar into the rectengular hole in the bottom of SC-5 gun lock. Using the supplied thick washers under flat bar mounting holes, bolt flat bar and gun lock assembly to the partition wall with 2 x 5/16-18" carriage bolts.
- Install weapon in Butt Plate and slide gun lock on flat bar to a suitable location on the weapon so when lock is closed you can not lift weapon out of the butt plate. Secure gun lock on flat bar using the supplied 5/32" allen key.
- Insert and remove weapon from the setup several times to make sure the weapon is secure and also easy to take it out of the setup. Tighten all screws.
We reserve the right to change design and prices without notice.
HELP IS JUST A PHONE CALL AWAY
Should you have any problem installing or using Santa Cruz products, we are here to help you every step of the way.
Just give us a call at our toll free number (800) 847-5428 and we will be glad to help you with the installation, special part request or any other way you might need assistance.
^Back to Top
|
